Ranger 4WD V6-4.0L (2009)
-
Install a Nm (lb-in) torque wrench on the pinion nut.
-
Rotating the pinion through several revolutions, take frequent cone and roller bearing torque preload readings until the original recorded
preload reading is obtained.
-
If the original recorded preload is lower than specifications, tighten to the appropriate specifications for used bearings. If the preload is higher
than specification, tighten the nut to the original reading as recorded. For additional information, refer to Specifications.
8. Position the rear driveshaft and align the marks on the pinion flange.
9. NOTE: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. To make sure that the yoke seats squarely on the
flange, tighten the bolts evenly in a cross pattern.
Install the 4 bolts.
-
Tighten to 112 Nm (83 lb-ft).
10. Install the rear brake drums.
11. Install the wheel and tire.
