Ranger 4WD V6-4.0L (2009)
Bearing cup removal
4. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the slip-yoke.
1. Position the yoke in the C-Frame and Screw Installer/Remover.
2. Press out a bearing cup.
3. Rotate the driveshaft slip-yoke 180 degrees.
4. Press on the spider to remove the remaining bearing cup and the U-joint.
5. Clean the driveshaft slip-yoke.
-
Inspect the driveshaft slip-yoke.
-
Install a new yoke as necessary.
Assembly
Bearing cup installation
1. NOTE: Install the U-Joint Kits as complete assemblies only. Do not mix components from other kits.
Install a new spider and bearing cup.
1. Start a new bearing cup in the shaft yoke.
-
Check the needle bearings for correct positioning.
2. Position the new spider in the shaft yoke.
3. Press the bearing cup to just below the snap ring groove using the C-Frame and Screw Installer/Remover.
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the U-joint. If difficulty is encountered with the yellow snap rings, install the
black snap rings.
Remove the shaft from the C-Frame and Screw Installer/Remover and install the new snap ring.
