Ranger 4WD V6-4.0L (2009)
2. Remove the differential pinion shaft.
6. Remove the U-washers.
1. Push the axle shafts inboard.
2. Remove the U-washers.
7. Remove the 2 axle shafts.
Installation
1. Lubricate the lip of the wheel bearing oil seal with grease.
2. NOTE: Do not damage the wheel bearing oil seal.
Install the 2 axle shafts.
3. NOTE: Do not damage the rubber O-rings in the axle shaft grooves.
Install the U-washers.
1. Position the 2 U-washers on the button end of the axle shafts.
2. Pull the axle shafts outward.
