Ranger 4WD V6-4.0L (2009)
Control Module: Service and Repair
4X4 Control Module
Removal and Installation
1. NOTICE: Before removing the audio unit, it must be placed in shipment mode. Failure to follow this instruction may result in damage to
the audio unit.
Put the audio unit in shipment mode.
2. Insert the Audio Unit Removing Tool, then remove and support the audio unit.
3. Disconnect the audio unit electrical connector(s) and antenna cable.
4. Remove the 2 instrument panel finish panel screws. Disengage the spring clips at the top. Remove the instrument panel finish panel.
