Ranger 4WD V6-4.0L VIN E (2001)
Differential Cover: Service and Repair
8.8 Inch Ring Gear Rear Drive Axle/Differential
DIFFERENTIAL HOUSING COVER
Materials
Removal
1. Raise and support the vehicle.
2. NOTE: Empty the lubricant into a clean container for reuse.
Remove the differential housing cover.
1. Remove the bolts and drain the lubricant from the differential housing.
2. Remove the differential housing cover.
Installation
1. CAUTION: The machined surfaces on the differential housing and the differential housing cover must be clean and free of oil before applying
the silicone sealant. Cover the inside of the rear axle prior to cleaning the machined surface to prevent contamination.
Clean the gasket mating surfaces.
2. CAUTION: Install the differential housing cover within 15 minutes of applying the silicone, or it will be necessary to apply new sealant.
Apply a continuous bead of silicone sealant to the differential housing cover.
