Ranger 4WD V6-4.0L VIN E (2001)
11. Remove the outboard halfshaft boot.
12. NOTE: If the grease is contaminated, clean and inspect the joint for wear. Install a new outboard CV joint and shaft assembly if worn/damaged.
Inspect the assembly for contaminated grease.
Assembly
1. Pack the outboard CV joint with grease.
1. Use Ford High Temp Constant Velocity Joint Grease E43Z-1gS90-A or equivalent meeting Ford specification ESP-M1C207-A.
2. Spread any remaining grease from the service kit evenly inside the outboard halfshaft boot.
2. NOTE: Clean the halfshaft boot mounting surfaces of excess grease before positioning the halfshaft boot into place.
Position the outboard halfshaft boot and outboard boot clamps.
1. Position the outboard halfshaft boot.
2. Position the boot clamps on the outboard halfshaft boot.
