Ranger 4WD V6-4.0L VIN E (2001)
Bell Housing: Service and Repair
Dowels, Flywheel Housing to Block
Removal and Installation
1. NOTE: Take care not to damage the flywheel housing to block dowel holes or the surface areas around the flywheel housing to block dowel hole
during removal.
Remove the flywheel housing to block dowels using a drift pin where the flywheel housing to block dowel is installed in an open hole and a pair of
locking pliers where the flywheel housing to block dowel is installed in a blind hole.
2. NOTE: Care should be taken to drive the flywheel housing to block dowel squarely into place until it is fully seated without damaging the
surrounding surface areas.
Install all flywheel housing to block dowels by driving them into place using a brass or plastic mallet.
