Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Fuel Injection Supply Manifold >
< Throttle Body
Streetka 2003.5 (01.2003-07.2005)
Mechanical Repairs
3 Powertrain / 303 Engine
303-04B Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)-1.6L Duratec-8V (Rocam)
Diagnosis and Testing
Removal and Installation
Fuel Charging Wiring Harness
Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)/1.6L Duratec-8V (Rocam) - Fuel Charging Wiring Harness
Streetka 2003.5 (01/2003-07/2005)
Removal and Installation
Materials
Name
Specification
Cable ties
Removal
Raise and support the vehicle. For additional information, refer to Section
100-02 Jacking and Lifting
.
Disconnect and detach the fuel charging wiring harness from the retaining bracket.
Lower the vehicle.
Remove the air cleaner. For additional information, refer to Section
303-12 Intake Air Distribution and Filtering
.
Remove the throttle body.
For additional information, refer to
Throttle Body -
in this section.
Disconnect the idle air control (IAC) valve and the T-MAP sensor electrical connectors. (intake manifold shown removed for clarity).
Detach the fuel charging wiring harness from the fuel injection supply manifold.
Cut the
cable ties
.
Disconnect the fuel injector electrical connectors.
Remove the fuel charging wiring harness through the intake manifold, where the throttle body was installed.
Installation
To install, reverse the removal procedure.
Mechanical Repairs
3 Powertrain / 303 Engine
303-04B Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)-1.6L Duratec-8V (Rocam)
Diagnosis and Testing
Removal and Installation
Fuel Charging Wiring Harness
Fuel Injection Supply Manifold >
< Throttle Body