ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
414-02 Generator and Regulator > < Battery Disconnect and Connect

Streetka 2003.5 (01.2003-07.2005)

Battery, Mounting and Cables - Battery to Starter Motor Solenoid Cable—1.3L Duratec-8V (Rocam)/1.6L Duratec-8V (Rocam) Streetka 2003.5 (01/2003-07/2005)
Removal and Installation

Materials
Name
Specification
Cable tie
 

Removal

  1. Disconnect the battery ground cable.
    For additional information, refer to Battery Disconnect in this section.
  1. Remove the air cleaner. For additional information, refer to Section  303-12 Intake Air Distribution and Filtering.

  1. Remove the battery positive terminal cover.

  1. Disconnect the battery positive cables.

  1. Detach the starter motor solenoid cable electrical connector from the retaining clip.

  1. Disconnect the starter motor solenoid cable electrical connector.

  1. Cut the cable ties and move the battery to starter motor solenoid cable to underneath the engine.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the protective cap and disconnect the generator electrical connector.

  1. Disconnect the ignition switch to starter motor solenoid and battery to starter motor solenoid cables.
  1. Remove the battery to starter motor solenoid cable.

Installation

  1. To install, reverse the removal procedure.

414-02 Generator and Regulator > < Battery Disconnect and Connect