ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Seat Cushion > < 501-10 Seating|Seats

Streetka 2003.5 (01.2003-07.2005)

Seating - Front Seat Streetka 2003.5 (01/2003-07/2005)
Removal and Installation

Removal

WARNING:
WARNING:To avoid accidental deployment the air bag control module backup power supply must be depleted. Wait at least one minute after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury.
WARNING:
WARNING:Note the position of the wiring harnesses, to aid installation. An incorrectly routed wiring harness could become damaged when the seat is moved. Failure to follow this instruction may result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Move the seat fully rearwards.

  1. Disconnect the electrical connectors.

  1. Remove the seat front retaining bolts.
  1. Move the seat fully forwards.

  1. Remove the seat rear retaining bolts.
  1. Remove the seat.

Installation

  1. To install, reverse the removal procedure. Tighten the seat retaining bolts in the following sequence:
    • Front inner bolt
    • Front outer bolt
    • Rear inner bolt
    • Rear outer bolt

Front Seat Cushion > < 501-10 Seating|Seats