Taurus L4-153 2.5L HSC (1986)
Upper Side Moulding / Trim: Customer Interest
Front Door Window Molding - Separates From Door
Article No. 86-12-1
EXTERIOR TRIM-FRONT DOOR - WINDOW MOULDING SEPARATES FROM DOOR
FORD 1986 TAURUS
LINCOLN-MERCURY 1986 SABLE
Separation of the front door window moulding from the door is caused by inadequate bonding and can be serviced by replacing the moulding assembly
with an improved design using the following procedure:
1.
Lower door window all the way down.
2.
Remove the plastic rearview mirror mounting hole cover (1 screw) from the front inside beltline area of the door.
3.
Remove and save the adhesive backed tape covering the mirror mounting access holes in the door inner panel.
NOTE:
These two holes will allow end wrench access to the three nuts retaining the mirror. It is not necessary to remove the door trim panel.
4.
Using an end wrench, remove the nuts (3) retaining the mirror to the door. Carefully pull the mirror away from the door as far as the slack in the
wiring assembly will allow.
5.
Remove the screw at the front end of the moulding assembly (previously covered by the mirror).
NOTE:
An offset screwdriver may be required.
