Taurus L4-153 2.5L HSC (1986)
Adjuster Screw Assembly
6. Install adjuster screw assembly between leading shoe slot and the slot in the trailing shoe and parking brake lever. The adjuster socket end slot
must fit into the trailing shoe and parking brake lever.
NOTICE: The adjuster socket blade is marked R or L for RH or LH brake assemblies. The R or L adjuster blade must be installed with the letter
R or L in the upright position (facing wheel cylinder) on the correct side to ensure that the deeper of two slots in the adjuster sockets fits into the
parking brake lever.
7. Assemble adjuster lever in the groove located in the parking brake lever pin and into the slot of the adjuster socket that fits into trailing shoe web.
8. Install shoe holddown springs.
NOTE: For additional information see Brake Spring Removal and Installation Notes.
Upper Retracting Spring
9. Attach upper retracting spring to leading shoe slot. Using an appropriate spring tool, stretch the other end of the spring into the notch on the
adjuster lever. If adjuster lever does not contact star wheel after installing the spring, it is possible that the adjuster socket is installed incorrectly.
10. Adjust brake shoes/linings.
