Taurus L4-153 2.5L HSC (1986)
Figure 4 - Article 87-7-5
ISSUE:
Insufficient heater airflow to the front floor area during low ambient temperatures may be caused by the current plenum chamber design.
ACTION:
To correct this, modify the plenum chamber by adding an additional hole on each side, Figure 3. Use a solder gun with a spade tip to cut the
holes. Refer to the following illustrated service procedure (Figures 3 and 4) for modification templates and the hole locations.
OTHER APPLICABLE ARTICLES: 86-4-5
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual
OPERATION: SP870705A
TIME:
0.3 Hr.
DLR. CODING:
Basic Part No. 18C433
Code: 55
