Taurus V6-182 3.0L (1987)
Figure 6
-
If camber measurement from Step 2 was out-of-specification in the negative direction, elongate hole horizontally on inboard side until
overall slot length measures 24 mm (0.94"), Figure 6.
-
If camber measurement from Step 2 was out-of-specification in the positive direction, elongate hole horizontally on outboard side until
overall slot length measures 16 mm (0.63"), Figure 6.
12.
Using floor jack, raise lower arm back up into crossmember pocket.
Figure 6
13.
Install kit inner pivot cam bolt from front side of crossmember. As cam bolt is being installed, the two (2) kit tab washers are to be installed on
bolt so that one (1) washer is trapped between each end of inner pivot bushing inner sleeve and inside surface of crossmember pocket, Figure 6.
14.
Place kit cam washer and nut on bolt, position tab washers to be in contact with crossmember bracket, and tighten nut to about 50 ft.lbs. (68 N-m),
Figure 6.
15.
Repeat Steps 7 through 14, for opposite side of vehicle.
16.
Reinstall stabilizer bar U-brackets and parking brake cable bracket.
