Taurus V6-182 3.0L (1987)
Note: Apply a small amount of Disc Brake Caliper Slide Grease D7AZ-19590-A (ESA-M1C172-A) or equivalent to pilot diameter of rotor.
12. Install disc brake rotor to hub assembly.
13. Install disc brake caliper over rotor.
14. Ensure outer brake shoe spring hook is seated under upper arm of knuckle.
15. Install wheel and tire assembly, tightening wheel lug nuts finger-tight.
16. Lower vehicle and block wheels to prevent vehicle from rolling.
17. Tighten wheel lug nuts to 109-142 NM (80-105 ft-lbs).
WARNING: REPLACEMENT LUG NUTS OR STUDS MUST BE OF THE SAME TYPE AND SIZE AS THOSE BEING REPLACED.
18. Install wheelcover or hub cover and lower vehicle completely to the ground.
19. Remove wheel blocks.
