Taurus V6-182 3.0L (1987)
3.
Install the spring, valve, plug and retainer into the bore.
4.
During in-vehicle main control installation, be sure to properly align the valve body and gasket to the case.
a.
There is a new shorter Valve Body Alignment Pin T94P-77100-A. Use the new alignment pin in the hole closest to the manual lever area.
b.
Use Valve Body Guide Pins T80L-77100-A in the hole diagonally opposite on the valve body. This allows both pins to remain installed in
the case holes while the manual valve linkage is attached, main control assembly is placed over pins and seated down onto the case gasket.
5.
Complete the main control assembly installation by tightening the main control assembly retaining bolts 72 to 82 lb.in. (8.1 to 9.3 N-m). Tighten in
the sequence shown in the Service Manual.
PART NUMBER
PART NAME
CLASS
F23Z-7F194-A
1-2 TV Modulator Spring
A
Retainer Plate
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS:
Eligible Under The Provisions Of The Bumper To Bumper Warranty Coverage For 1992-93 Models. Eligible Under Basic And Powertrain Warranty
For All Other Models.
OPERATION DESCRIPTION
TIME
940106A
Remove Valve Body,
1.2 Hrs.
Replace Spring Retaining
Plate, Install Valve Body
DEALER CODING
BASIC PART NO.
CONDITION CODE
7F194
63
OASIS CODES: 501000
