Taurus V6-182 3.0L (1987)
TAURUS/SABLE STATION WAGONBACKLITE GLASS BREAKAGE
B.
Remove brown backing from sealer masks and stick mask to glass as shown in Attachment 6 for the lower terminals.
C.
Using a small fine bristle brush, apply a heavy coating of adhesive/sealant (approx. 1/16 inch thick) on area inside of mask, including
terminal attachment to glass.
NOTE:
APPLY THE HEAVY COAT AS SMOOTHLY AS POSSIBLE. DO NOT GET ADHESIVE/SEALANT ON ELECTRICAL
TERMINAL BLADES WHICH PLUG INTO WIRE CONNECTORS.
D.
After adhesive/sealant has been applied, immediately remove mask, without smearing adhesive/sealant.
12.
Carefully install connectors to terminals on glass.
