Taurus V6-182 3.0L DOHC SHO (1992)
Parking Brake Lever Assembly
2. Grease parking brake shaft recess and slightly grease parking brake lever shaft. Insert shaft into bore in caliper housing.
3. Screw return spring stop bolt into caliper housing. Tighten to 6-9 Nm (4.5-7 ft lb). Attach parking brake lever return spring to stop bolt and insert
free end into parking brake lever slot.
4. Install a new O-ring seal in groove of push rod. Grease recess at push rod end with silicone dielectric grease.
Push Rod Assembly
5. Position strut pin into caliper housing and in recess of parking brake lever shaft. Insert push rod into push rod bore of caliper housing. Ensure pin
is positioned correctly between shaft recess and recess at end of push rod. Place key plate over push rod so that locating nib fits into drilled
locating hole in caliper housing. Install flat washer, push rod, spring and spring cover in order.
Outer Spacer
6. Insert outer spacer into piston bore.
