Taurus V6-182 3.0L DOHC SHO (1992)
A/C Coil Pressing Tool - Installation
3. Position the Coil Pressing Installer Tool T89P-19623-EH or equivalent in position over the compressor nose and to the inner diameter of the field
coil.
4. Position the 2-Jaw Puller D80L-1002-L or equivalent to the compressor and Field Coil Pressing Tool. The jaws of the puller should be firmly
engaged with the rear side of the compressor front mounts. The forcing screw must be piloted on the center mark of the pressing tool.
5. Tighten the forcing screw with a wrench until the coil is pressed on the compressor front head.
CAUTION: Do not use air tools.
6. Ensure that the field coil bottoms against the head at all points around the circumference of the coil mounting surface.
7. Install the clutch pulley and hub on the compressor. Adjust the air gap as necessary.
8. Install the compressor on the vehicle.
