Taurus V6-182 3.0L DOHC SHO (1992)
Power Steering Line/Hose: Service and Repair
Supply Line Replacement
REMOVAL
1.
Disconnect negative battery cable.
2.
Remove the engine dampner shock.
3.
Remove the power steering belt.
4.
Loosen supply line hose clamp at reservoir and remove hose.
5.
Drain fluid in a suitable container.
6.
Remove strap retaining supply line to return line.
7.
Raise the vehicle on hoist.
8.
Remove the RH front wheel and tire assembly.
9.
Position adjustable jack under engine.
10.
Remove RH rear engine mount.
11.
Remove the power steering pump pulley.
12.
Position drain pan under pump.
13.
Disconnect supply line at pump.
14.
Remove supply line from vehicle.
INSTALLATION
1.
Position supply line in vehicle.
2.
Connect supply line hose to pump. Tighten hose clamp to 13-17 lb. in. (1.4-2.0 Nm).
3.
Install power steering pump pulley.
4.
Install RH rear engine mount.
5.
Remove jack.
6.
Install wheel and tire assembly.
7.
Remove the drain pan.
8.
Lower vehicle.
9.
Install engine damper shock.
10.
Install strap to secure supply line to return line.
11.
Connect negative battery cable.
12.
Fill system, See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
