Taurus V6-182 3.0L DOHC SHO (1992)
Knuckle On Press (UP)
16. Using a hydraulic press, place Front Bearing Spacer T86P-1104-A2 or equivalent step side up on press plate and position knuckle (outboard side
up) on the spacer. Install Front Bearing Remover T83P-1104-AH2 or equivalent centered on the bearing inner race and press bearing out of the
knuckle.
17. Discard bearing.
Installation
1. On bench, remove all foreign material from knuckle bearing bore and hub bearing journal to ensure correct seating of new bearing.
Note:
-
If hub bearing journal is scored or damaged, replace hub. Do not attempt to service.
-
The front wheel bearings are of a cartridge design and are pregreased, sealed, and require no scheduled maintenance.
-
The bearings are preset and cannot be adjusted.
-
If a bearing is disassembled for any reason, it must be replaced as a unit. No individual service seals, roller or races are available.
