Taurus V6-182 3.0L DOHC SHO (1992)
Removal
1. Remove nut to remove outboard belt and buckle assembly.
2. Remove inboard retractor. Remove rear seat back.
3. Remove three screws retaining front panel of load floor assembly.
4. Remove the front panel. Reach between floorpan and load floor and remove the nut to pull out the retractor.
Installation
1. To install, reverse removal procedure. Position belts as shown.
2. Tighten all retaining nuts to 60-90 N.m (44-66 lb-ft). Cycle retractor several times to ensure proper operation of retractor. Make sure safety belt is
not twisted.
Outboard
Outboard
Removal
1. Remove nut to remove outboard belt and buckle assembly.
2. Remove inboard retractor. Remove rear seat back.
3. Remove three screws retaining front panel of load floor assembly.
4. Remove the front panel. Reach between floorpan and load floor and remove the nut to pull out the retractor.
Installation
1. To install, reverse removal procedure. Position belts as shown.
2. Tighten all retaining nuts to 60-90 N.m (44-66 lb-ft). Cycle retractor several times to ensure proper operation of retractor. Make sure safety belt is
not twisted.
