Taurus V6-182 3.0L DOHC SHO (1992)
Wheel Bearing: Service and Repair
Rear - With Drum Brakes
Bearing and Hub Assembly, Drum Brakes
Removal
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove two pushnuts retaining drum to hub and remove drum.
4. Remove grease cap from bearing and hub assembly and discard cap.
5. Remove hub retaining nut.
6. Remove bearing and hub assembly from spindle.
Drum Brakes - Hub And Bearing
Installation
1. Position bearing and hub assembly on spindle.
2. Install hub retaining nut and tighten to 255-345 NM (188-254 ft-lbs).
3. Install new grease cap using Coil Remover T89P-19623-FH or equivalent. Tap on tool until grease cap is fully seated.
4. Install brake drum on hub.
Install two pushnuts that retain drum.
5. Install wheel and tire assembly.
6. Lower vehicle.
