ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/T - AXODE/AX4S No Gear Engagement/Noise|Page 5028 > < A/T - AXODE/AXOD New Design Filter Service Tip
Page 1
background image

Planetary Gears: Customer Interest
A/T - AXODE/AX4S No Gear Engagement/Noise

Article No. 
94-20-9

10/05/94

TRANSAXLE - AXOD-E/AX4S - REVISED REAR LUBE TUBE RETENTION BRACKET

FORD:
1991-95 TAURUS 
1993-95 TAURUS SHO

LINCOLN-MERCURY: 
1991-94 CONTINENTAL 
1991-95 SABLE

LIGHT TRUCK:
1995 WINDSTAR

ISSUE:
Some vehicles equipped with AXOD-E/AX4S Transaxles may experience a lack of Drive and/or Reverse when the vehicle is at a standstill or a reduced
amount of drive and/or reverse (that may be preceded by a grinding or popping noise) during vehicle motion which causes a gradual slowing. This may
be caused by the radial seal rear lube tube coming out of the case hole at the chain cover end of the transaxle. The loss of adequate lubrication to the
front and rear planetary systems can result in planetary wear-out.

ACTION:
Install SHO-type tube retention brackets, which provide improved retention of the rear lube tube to prevent the tube from coming out of its position in
the case. Refer to the following procedure for service details.

Use the two-piece design main tube bracket assembly kit (upper and lower brackets) with a center screw and a new flatted low/intermediate servo release
tube, Figure 1, when:

A/T - AXODE/AX4S No Gear Engagement/Noise|Page 5028 > < A/T - AXODE/AXOD New Design Filter Service Tip