Taurus V6-182 3.0L FF (1995)
With the ignition switch in RUN and the voltmeter connected between Circuit 151 (LB/Bk) in the 6-pin connector and ground, press and hold the
SET/ACCEL button on steering wheel. Voltmeter should indicate approximately 4.5 volts. Rotate the steering wheel back and forth and watch the
voltmeter for fluctuations. If the voltage varies more than 0.5 volt, perform the speed control actuator switch test.
COAST Circuit
With the ignition switch in RUN and the voltmeter connected between Circuit 151 (LB/BK) in the 6-pin connector and ground, press and hold the
COAST button on steering wheel. The voltmeter should indicate approximately 1.5 volts.
RESUME Circuit
With the ignition switch in RUN and the voltmeter connected between Circuit 151 (LB/BK) in the 6-pin connector and ground, press and hold the
RESUME button on the steering wheel. The voltmeter should read approximately 6.5 volts.
NOTE: Do not substitute a good speed control amplifier until the speed control servo test has been successfully completed.
If all the circuits check OK, perform the speed control servo test and substitute a known good speed control amplifier.
