Taurus V6-182 3.0L FF (1995)
3.
Remove the wire harness from the retainer on the cooling fan. See Figure 6.
4.
Connect the two (2) CBM electrical connectors to their respective wire harness connectors. See Figure 7.
5.
Position the CBM onto the upper radiator support and install the supplied nut onto the stud.
Tighten the nut to 10 Nm (88 lb-in). See Figure 7.
6.
Route the cooling fan shroud wire harness and secure it in the retainer at the top of the cooling fan module. See Figure 7.
7.
Position the radiator upper sight shield onto the vehicle and install the fasteners.
8.
Connect the battery negative cable and set radio stations.
9.
Check cooling fan operation.
Mustang 3.8L and 5.0L H0
1.
Record radio preset stations, then disconnect the battery negative cable.
2.
CAUTION: When securing the CBM to the fan shroud with the tie strap, be sure to wrap the tie strap around two (2) fan supports only and NOT a
fan blade.
CAUTION:
The CBM for the 3.8L Mustang has one (1) circuit breaker, and the module for the 5.0L has two (2). Make sure the CBM you are installing is for the
appropriate engine configuration. If the wrong part is installed on the vehicle, it will fail to protect the circuit.
