Taurus V6-182 3.0L FF (1995)
3.
Remove the sight shield from above the radiator and engine cooling fan area.
4.
Disconnect existing vehicle wiring harness connector from cooling fan motor harness.
5.
Remove and discard the retainer from the supplied harness.
CAUTION:
Dry fit all of the connectors. Do not use any conductive lubricant.
6.
Connect jumper harness to the cooling fan motor harness and to existing vehicle harness.
NOTE:
The fuse holder is to be mounted under the radiator support sheet metal at the hole provided approximately two (2) inches to the left of the air bag
crash sensor.
7.
Using the supplied nut and bolt attach fuse holder to the under side of the radiator support sheet metal. Tighten to 3.5-4.5 Nm (31-41 lb/in). Refer
to Figure 6.
8.
Connect battery negative cable, then remove memory saver.
9.
Check cooling fan motor for proper operation.
10.
Install sight shield.
11.
Close hood.
FCSD Regional Managers Letter
To:
All FCSD Regional Managers
