Taurus V6-182 3.0L FF (1995)
2.
Install memory saver, then disconnect battery negative cable.
3.
Remove air intake tube resonator assembly from upper radiator support, it equipped.
4.
Disconnect the existing wiring harness connector from the engine cooling fan motor. Disconnect the push pin retainer securing the existing vehicle
harness to the shroud webbing. The webbing is made of thin material and can break easily. Use caution in removal.
5.
Using a 9/32 inch drill bit, drill a hole in the shroud straight down at the 12 o'clock position and 3/8 inch in from the back edge. See Figure 1.
CAUTION:
Dry fit all of the connectors. Do not use any conductive lubricant.
6.
Connect the jumper harness to the fan motor and to the existing vehicle wiring harness.
7.
Remove fan shroud retaining screw from upper left corner.
8.
Position fuse holder to upper left corner of shroud and reinstall retaining screw. Tighten to 3.5-4.5 Nm (31-41 lb/in). See Figure 1.
9.
Attach existing vehicle wire harness push pin retainer to the newly drilled hole in the top of the fan shroud.
10.
Attach the jumper harness to the existing hole in back of the shroud using the push pin retainer supplied. See Figure 1. Please note that some
models will use only one retainer.
11.
Install resonator assembly, if equipped.
12.
Connect battery negative cable, then remove memory saver.
13.
Check cooling fan motor for proper operation.
14.
Close hood.
Affected Vehicles:
1994-1995 Taurus (except SHO)/Sable Equipped with 3.0L Engine
Required Parts:
F43Z-14K095-CA
