Taurus V6-182 3.0L FF (1995)
Installation Procedure:
1.
Open hood.
2.
Install memory saver, then disconnect battery negative cable.
3.
Disconnect existing vehicle wiring harness connector from cooling fan motor. Disconnect wire loom and retainer from fan shroud.
4.
Remove upper left fan shroud retaining nut.
5.
Position fuse holder mounting bracket over retaining stud with fuse in upright position. Reinstall retaining nut and tighten to 3.5-4.5 Nm (31-41
lb/in).
CAUTION:
Dry fit all connectors. Do not use any conductive lubricant.
6.
Connect jumper harness to the cooling fan motor and to existing vehicle harness.
7.
Position female connector to the fan shroud as shown in Figure 2. Keeping the connector as low as possible and still making sure it stays flat
against the shroud, mark the location of the two (2) mounting holes on the shroud.
8.
Disconnect female connector and position connector halves out of the way.
CAUTION:
The radiator is located directly behind the area to be drilled. Use a drill stop or other devise to prevent damage to the radiator.
