Taurus V6-182 3.0L FF (1995)
A/C Coil Pressing Tool - Installation
3. Place the Coil Pressing Tool T89P-19623-EH with the Field Coil Replacer T91P-19623-CH in position over the compressor nose and to the inner
radius of the A/C clutch field coil.
4. Position the 2-Jaw Puller D80L-1002-L or equivalent on the A/C compressor and coil pressing tool. The jaws of the puller should be firmly
engaged with the rear side of the A/C compressor front mounts. The forcing screw must be piloted on the center mark of the pressing tool.
5. Tighten the forcing screw with a hand wrench until the A/C clutch field coil is pressed on the compressor front head. Check to make sure that the
A/C clutch field coil bottoms against the head at all points around the A/C clutch field coil outer diameter.
6. Install the A/C clutch pulley and the A/C clutch on the A/C compressor.
7. Check and adjust A/C clutch air gap.
8. Install the A/C compressor on the vehicle.
