Taurus V6-182 3.0L FF (1995)
Conditioning/Service and Repair/ See: Service and Repair
6. Disconnect the condenser to the evaporator tube and the suction accumulator/drier inlet tube from the A/C evaporator core at the dash panel. Cap
the refrigerant lines and the A/C evaporator core tube to prevent the entrance of dirt and excess moisture.
7. Disconnect the heater water hoses from the heater core tubes and plug the heater water hoses with suitable 5/8 inch and 3/4 inch plugs. Cap the
heater core tubes to prevent coolant loss from the heater core during removal of the A/C evaporator housing.
8. Disconnect the vacuum supply hose from the A/C vacuum check valve in the engine compartment.
9. Remove the screw holding the instrument panel shake brace to the A/C evaporator housing and remove the instrument panel shake brace.
10. Remove the two screws retaining the heater outlet floor duct and the rear seat air flow duct to the bottom of the A/C evaporator housing.
11. Remove the three nuts retaining the A/C evaporator housing to the dash panel in the engine compartment.
12. Remove the two screws retaining the support brackets to the cowl top panel. Carefully pull the heater core case away from the dash panel and
remove the A/C evaporator housing from the vehicle.
INSTALLATION
