Taurus V6-182 3.0L FF (1995)
Combination Switch: Description and Operation
Multifunction Switch
Multi-Function Switch
The multi-function switch assembly, which is mounted to the steering actuator housing, provides electrical switching for:
-
turn signal.
-
headlamp dimmer.
-
headlamp flash-to-pass.
-
hazard warning.
-
cornering lamps.
-
windshield washer/wiper.
The intermittent wiper control switch, located in the knob at the end of the multi-function switch, operates as follows:
-
The ignition switch must be in the RUN position to operate wiper.
-
In addition to OFF, there are two fixed wiper speed positions, LO and HI, as well as an interval position.
-
Positions are selected by rotating the knob actuator relative to the turn signal lever.
-
If interval position is selected, the time between wiper cycles will decrease as the knob is rotated away from the OFF position and increase as
the knob is rotated toward the OFF position.
-
The time interval between wipes will vary depending on the knob's position from OFF.
