Taurus V6-182 3.0L FF (1995)
2.
Transfer oil pump intermediate shaft from old camshaft position sensor housing to replacement camshaft position sensor housing.
3.
Install camshaft position sensor housing so that drive gear engagement occurs when arrow on locator tool is pointed approximately 30 degrees
counterclockwise from the rear face of the cylinder block. This step will locate camshaft position sensor electrical connector in the pre-removal
position.
4.
Install hold-down clamp (washer and bolt) and tighten to 20-30 Nm (15-22 lb-ft).
5.
Remove Syncro Positioning Tool T93P-12200-A.
6.
CAUTION: If camshaft position sensor electrical connector is not positioned properly, DO NOT reposition the connector by rotating the
camshaft position sensor housing. This will result in the ignition system and fuel system being out of time with the engine, possibly causing engine
damage. Remove the camshaft position sensor housing and repeat installation procedure, beginning with Step 1.
Install camshaft position sensor and retaining screws. Tighten screws to 2.5-3.5 Nm (22-31 lb-in).
7.
Connect fuel charging wiring connector to camshaft position sensor.
8.
Connect battery ground cable.
