Taurus V6-182 3.0L FF (1995)
Side Air Bag: Service and Repair
Passenger Side Air Bag
NOTE: If the passenger side air bag module did not deploy in a collision, it may not have been needed. Complete all diagnosis before replacing the
passenger side air bag module.
REMOVAL
WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE
BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE NEGATIVE CABLE MUST BE
DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.
1. Disconnect negative battery cable.
2. Wait one minute for energy to be depleted.
3. Remove RH and LH finish panel.
4. Remove instrument panel finish panel retaining spear clips.
5. Open glove compartment, press side inward and lower glove compartment to floor.
6. Through glove compartment opening, remove two lower passenger air bag module rear retaining screws.
7. Remove four remaining passenger air bag module front retaining screws from side of air bag cover.
WARNING: PLACE AIR BAG MODULE ON BENCH WITH TRIM COVER FACING UP TO AVOID ACCIDENTAL
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
8. Disconnect electrical connector attached to LH side of passenger side air bag module and remove passenger side air bag module.