Taurus V6-182 3.0L FF (1995)
-
The safety belt has a tongue that latches to the rear safety belt and buckle and continues through the tongue outboard to the floor.
Jump Seat Lap Safety Belt
The auxiliary safety belt consists of a safety belt and buckle assembly on the outboard side and safety belt retractors with tongue on inside. Both are
mounted to the floorpan.
-
To fasten the safety belt, pull safety belt out of the retractor with a steady motion and insert the tongue into the buckle.
-
Adjust safety belt snug around hips (never across the waist) and return excess safety belt into retractor. Failure to do so may result in injury,
especially in a rear end collision.
Unfastening Safety Belts With Retractors
-
Push the release button on the end of the buckle. This allows the tongue to unlatch from the buckle.
-
While the belt retracts, guide the tongue to its original position to prevent it from striking the technician or the vehicle.
Safety Belt Extension Assembly
A safety belt that is too short even when fully extended can be lengthened. Safety belt extension assembly is available. This assembly will add
approximately 20 cm (8 inches) to the length of the safety belt. Safety belt extensions are available at no cost from any authorized Ford or
Lincoln/Mercury dealer.
