Taurus V6-182 3.0L FF (1995)
Index
Wheel hubs (1104) and front wheel bearings (1215) are installed as follows:
-
Each front wheel (1007) is bolted to a wheel hub.
-
The front wheel bearing assembly is pressed into the front wheel knuckle/bore from the inboard side until it rests against the shoulder on the
outboard side.
-
A snap ring is installed in a groove on the inboard side of the bore for added bearing retention.
-
The wheel hub assembly is pressed into the front wheel bearing located on the front wheel knuckle (3K1 86).
-
The front wheel driveshaft and joint splined shaft is pressed through the wheel hub.
-
A prevailing torque wheel hub retainer retains the wheel hub assembly to the front wheel driveshaft and joint (3B436).