Taurus V6-182 3.0L FF (1995)
Knuckle Step Side Up
16. Using a hydraulic press, place Front Bearing Spacer T86P-1104-A2 step side up on press plate and position front wheel knuckle (outboard side
up) on the spacer. Install Front Bearing Remover T83P-1104-AH2 centered on the bearing inner race and press front wheel bearing out of the front
wheel knuckle.
17. Discard front wheel bearing.
Installation
1. On bench, remove all foreign material from knuckle bearing bore and hub bearing journal to ensure correct seating of new bearing.
Note:
-
If hub bearing journal is scored or damaged, replace hub. Do not attempt to service.
-
The front wheel bearings are of a cartridge design and are pregreased, sealed, and require no scheduled maintenance.
-
The bearings are preset and cannot be adjusted.
-
If a bearing is disassembled for any reason, it must be replaced as a unit. No individual service seals, roller or races are available.
