Taurus V6-182 3.0L FF (1995)
3. Install CV joint assembly into outer race and pivot 90° into position.
4. Align bearing cage and inner race with outer race, then tilt inner race and install a ball, followed by remaining five balls.
Fig. 10 Halfshaft End Identification
5. Determine which end of driveshaft is for outboard CV joint. The outboard joint side has a shorter end of boot groove to end of shaft dimension.
6. Install CV joint boot and small boot clamp. If stop ring was removed, install at this time. If stop ring was not removed, ensure it is seated properly
in groove.
