Taurus V6-183 3.0L VIN U FI (1993)
6.
Position female connector to the fan shroud as shown in Figure 1-BB. Keeping the connector as low as possible and still making sure it stays flat
against the shroud, mark the location of the two (2) mounting holes on the shroud.
7.
Disconnect female connector and position connector halves out of the way.
CAUTION
The radiator is located directly behind the area to be drilled. Use a drill stop or other device to prevent damage to the radiator.
8.
Using a 9/32 inch drill bit, drill two (2) holes at locations marked in step 6.
CAUTION
Dry fit all of the connectors. Do Not use any conductive lubricant.
9.
Reconnect female connector to vehicle wire harness. Using the two (2) push pin retainers provided, attach the jumper harness connector to the fan
shroud at the holes drilled. Refer to Figure 1-BB.
10.
Connect battery negative cable.
11.
Check engine cooling fan motor for proper operation.
12.
Close hood.
Attachment III - Technical Instructions - Kit CC
Technical Instructions
Engine Cooling Fan Motor Wiring Harness Circuit Protection Modification
Kit CC Designated Vehicles
