Taurus V6-183 3.0L VIN U FI (1993)
Temperature Gauge: Testing and Inspection
Analog Instrument Cluster
1.
Turn ignition switch to On or ACC position.
2.
Connect a 10 ohm resistor between gauge lead and ground. The centerline of pointer should fall within the band around the H mark.
3.
Connect a 73 ohm resistor between gauge lead and ground. The centerline of pointer should fall within the band around the C mark.
4.
If gauge tests within calibration, replace sender.
5.
If gauge is out of calibration, replace gauge.
