Taurus V6-183 3.0L VIN U FI (1993)
3.
Remove right and left instrument panel moldings. Refer to Figure 1.
4.
Set parking brake.
5.
Position gearshift selector in First gear position.
6.
Remove instrument panel cluster opening finish panel. See Figure 1.
7.
Remove and discard headlamp switch.
8.
Inspect headlamp switch electrical connector for heat damage. If the electrical connector exhibits obvious heat damage, it must be replaced. Obtain
harness kit part # F80Z-11654-AA and install harness connector according to the instructions in this attachment. If the electrical connector does
not exhibit obvious heat damage, proceed to next step.
NOTE:
Perform the following step only if the headlamp switch electrical connector is not damaged.
