Taurus V6-183 3.0L VIN U FI (1993)
7.
Detach headlamp/dimmer switch trim panel by pulling at the LH end to unsnap it from the instrument cluster finish panel. See Figure 4.
8.
Twist out bulb socket from the trim panel then remove trim panel from the vehicle.
9.
Remove instrument cluster opening finish panel as follows:
^
Remove two (2) screws retaining the LH end.
^
Remove two (2) screws at the top of cluster opening.
^
Pull out at the LH side of panel and disconnect two (2) electrical connectors.
^
Remove instrument cluster opening finish panel. See Figure 4.
10.
Remove and discard headlamp switch.
11.
Inspect headlamp switch electrical connector for heat damage. If the electrical connector exhibits obvious heat damage, it must be rep laced.Obtain
harness kit part # F8LZ-11654-BA and install harness connector according to the instructions on Page 13 of this attachment. If the electrical
connector does not exhibit obvious heat damage, proceed to next step.
NOTE:
Perform the following step only if the headlamp switch electrical connector is not damaged.
