Taurus V6-183 3.0L VIN U FI (1993)
12.
Remove terminal B3 from the headlamp switch electrical connector. See Figure 5. Cut terminal end off wire 13 mm (1/2 inch) from
connector.Splice on new wire with correct terminal end obtained from switch + B3 kit, F8LZ-11654-CA. Install terminal into B3 terminal slot of
connector.
13.
Install new headlamp switch.
14.
Reconnect two electrical connectors.
15.
Install instrument cluster opening finish panel.
16.
Install bulb socket in headlamp/dimmer switch trim panel, then install trim panel.
17.
Install headlamp switch knob.
18.
Install upper steering column opening cover.
19.
Raise steering column to installed position. Tighten retaining nuts to 13-17 Nm (9-13 lb/ft).
20.
Install A/C recirculating air duct.
21.
Install steering column lower opening cover (knee bolster).
22.
Connect battery negative cable, then remove memory saver.
23.
Check operation of headlamp switch.
Sable
1.
Install memory saver, then disconnect battery negative cable.
2.
Remove knee bolster.
3.
Remove ignition switch lock cylinder.
4.
Remove tilt lever from steering column.
5.
Remove both upper and lower steering column shrouds.
6.
Remove headlamp switch knob, then the headlamp switch retaining nut.
