Taurus V6-183 3.0L VIN U FI (1993)
Distributor Assembly, (3.8L Shown, 3.0L Similar)
INSTALLATION
1. Place distributor stator over bushing and install into seat.
2. Place stator connector in position. Tab in notch on distributor housing and fastening eyelets aligned with screw holes.
3. Position stator wires away from moving parts.
4. Install two stator retaining screw or screws (depending upon application) and tighten to 1.7-4.0 Nm (15-35 in lb).
5. Install octane rod and retaining screw. Tighten to 1.7-4.0 Nm (15-35 in lb).
6. Apply a light coat of Motor Oil XO-10W30-QSP or -DSP or equivalent meeting Ford specification ESE-M2C153-E to distributor shaft below
armature.
7. Insert distributor shaft through distributor housing bushing.
8. Install distributor shaft collar and roll pin.
