Taurus V6-183 3.0L VIN U FI (1993)
e.
After installing all tubes and seating the upper tube bracket on the case bosses, the lower bracket assembly (thin stock steel with an
off-center hole in it) can be placed on top of the upper bracket and located by starting the two (N807811-SVMR) bolts (one of the bolts is
part of the lower assembly) into the threaded case holes.
NOTE:
TO AID IN INSTALLATION OF THE M5 CENTER SCREW (N807812-SVMR), THE SCREW CAN BE PLACED THROUGH THE HOLE IN
THE LOWER BRACKET BETWEEN THE LOW/INTERMEDIATE SERVO APPLY (LISA) AND RELEASE (LISR) TUBES, AND HAND
STARTED INTO THE NUT IN THE UPPER BRACKET.
f.
Tighten the two N807811-SVMR bolts to 9-12 N-m (80-106 lb.in.). Tighten the N807812-SVMR M5 center screw until the screw contacts
the lower bracket and the bracket contacts both the LISA and LISR tubes (usually about 2.5 N-m (22 lb.in.).
The bracket kit F4DZ-7G353-B includes the following:
^
1 (one) main bracket
^
1 (one) upper bracket
^
1 (one) bolt
^
1 (one) screw
Parts Block
OTHER APPLICABLE ARTICLES: 93-16-5
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 501000, 502000, 503000, 504000
