Taurus V6-183 3.0L VIN U FI (1993)
REMOVAL
1. Install soft vise jaw caps in vise to prevent damage to driveshaft, then position driveshaft in vise. Do not allow the vise to contact the CV joint boot
or clamps.
Fig. 3 Boot Clamp Removal
2. Using side cutting pliers, cut large boot clamp and peel away from boot. Roll boot back over driveshaft.
Fig. 4 Internal Snap Ring Removal
3. Turn driveshaft over in vise, then angle CV joint so that inner bearing race is exposed. Using a brass drift and a hammer, give a sharp rap to inner
bearing race to dislodge internal snap ring. Separate CV joint from driveshaft. Take care not to drop the joint. Remove CV boot from shaft.
4. Inspect CV joint grease for contamination. If grease appears contaminated or has a gritty feeling, inspect for worn components and replace as
necessary. If grease is not contaminated and joint was operating satisfactorily, add grease and replace boot.
