Taurus V6-195 3.2L DOHC SHO (1994)
Antenna Motor: Service and Repair
Removal and Installation
1. Push in on sides of glove compartment door and place glove compartment door in hinged downward position.
2. Disconnect radio antenna lead in cable from RH rear of radio chassis and remove from heater or A/C cable retaining clips.
3. Remove RH front fender splash shield. Unplug co-axial cable from automatic power electric antenna assembly or manual antenna base assembly.
Unplug power lead from automatic power electric antenna.
NOTE: The manual antenna mast is detachable from the radio antenna base and cable assembly.
4. Under RH front fender, pull radio antenna lead in cable through hole in door hinge pillar and remove radio antenna lead in cable from wheel well
area.
5. To remove manual or power antenna base, remove radio antenna nut and radio antenna stanchion on right RH front fender.
6. Remove lower antenna base screw and remove either manual antenna base or automatic power electric antenna.
