Taurus V6-195 3.2L DOHC SHO (1994)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
1. Disconnect battery ground cable, then remove anti-lock control module and bracket.
Fig. 150 Hydraulic Control Unit Replacement
2. Disconnect 19-pin connector from Hydraulic Control Unit HCU wiring harness, then disconnect 4-pin connector from HCU motor pump relay.
3. Remove two inlet and four outlet port tubes from HCU, then plug each port to prevent spilling brake fluid.
4. Remove relay mounting bracket nut.
5. Remove HCU assembly to mounting bracket nuts, then the assembly.
6. Reverse procedure to install.
7. Torque three nuts to 12-18 ft lb.
