Taurus V6-195 3.2L DOHC SHO (1994)
Brake Pad: Service and Repair
Removal and Installation
NOTICE: Ensure that one of the two slots in piston face is positioned so it will engage nib on brake pad.
Removing/Installing Piston
1. Using Rear Caliper Piston Adjuster T87P-2588-A rotate piston clockwise until it is fully seated.
2. Install inner and outer pad assemblies on anchor plate.
3. Rotate caliper assembly over rotor into position on anchor plate. Ensure that pad and lining assemblies are installed correctly.
Pinch Bolt And Slider Pin
4. Remove residue from the pinch bolt threads and apply one drop of Threadlock and Sealer E0AZ-19554-AA or equivalent. Install and tighten guide
pin bolts to 31-35 Nm (23-26 ft lb).
