ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Sensors and Switches - Brakes and Traction Control > < Electronic Brake Control Module|Locations|Page 5828
Page 1
background image

Electronic Brake Control Module: Service and Repair

1. Disconnect battery ground cable.
2. Remove trim panel in luggage compartment, located behind back seat, to expose the electronic control module.
3. Disconnect the 55-pin connector by pulling up lever completely, then move connector away from Anti-Lock Brake System (ABS) module until all

terminals are clear.

4. Remove screws, then the ABS module.
5. Reverse procedure to install.

Sensors and Switches - Brakes and Traction Control > < Electronic Brake Control Module|Locations|Page 5828